Control module for heat pump, boiler or other heating / cooling device. Mutually exclusive summer / winter.
The D-3THHC is an auxiliary control for cycle control of heat pumps or similar machines that require switching to heating or cooling.
This module follows the summer or winter cycle in the house and has its own relay for a single contact or two contacts to switch on the summer or winter cycle.
It also allows you to switch off/on the heat pump or use auxiliary circulation pumps.
This module is not associated with any specific panel and follows the cycle of all machines in the house.
No, this module does not even support a panel. Only modules with letter W at the beginning can support panels.
No, this module does not even support a panel. Only modules with letter W at the beginning can support panels.
This module is not intended to control machines present in each division, but centralized management of the heat or cold source.
This module is not intended to control machines present in each division, but centralized management of the heat or cold source.
No, this module follows the current cycle of the house, it can be changed using any T-OLED panel or the APP in Clima Control.
No, this module follows the current cycle of the house, it can be changed using any T-OLED panel or the APP in Clima Control.
Yes, it is possible. However, as it is supposed to control the primary source of heating or cooling it is not typically necessary to place more than 1 per house. If this is the case, consult our technical and commercial department so that we can understand your needs and look for the best solution together.
Yes, it is possible. However, as it is supposed to control the primary source of heating or cooling it is not typically necessary to place more than 1 per house. If this is the case, consult our technical and commercial department so that we can understand your needs and look for the best solution together.
No, this module does not have binary inputs. The inputs are used to connect motion sensors, brightness, timers or others.
No, this module does not have binary inputs. The inputs are used to connect motion sensors, brightness, timers or others.
This module can be mounted anywhere, as long as the BUS communication and humidity conditions are safeguarded so that it works correctly. DIN rail mounting is recommended.
This module can be mounted anywhere, as long as the BUS communication and humidity conditions are safeguarded so that it works correctly. DIN rail mounting is recommended.
Yes, this module exclusively connects one of the Summer or Winter contacts, so it can be used on pumps that have two contacts because it will never require both at the same time. In the case of a heat pump that needs a single presence contact for summer and absence for winter, switch on only the corresponding contact and in the opposite cycle the contact will be off.
Yes, this module exclusively connects one of the Summer or Winter contacts, so it can be used on pumps that have two contacts because it will never require both at the same time. In the case of a heat pump that needs a single presence contact for summer and absence for winter, switch on only the corresponding contact and in the opposite cycle the contact will be off.
The cycle can be changed via App 3.0 or on a T-OLED associated with any thermostat.
In APP 3.0, press the clima control button on the bottom bar and choose the cycle.
On the T-OLED enter configuration mode and toggle the cycle from summer mode to winter mode.
The cycle can be changed via App 3.0 or on a T-OLED associated with any thermostat.
In APP 3.0, press the clima control button on the bottom bar and choose the cycle.
On the T-OLED enter configuration mode and toggle the cycle from summer mode to winter mode.
Subscribe to our newsletter and receive news, tips and offers Atouch
